How to replace the vibration mirror of the ring motor(ring motor) laser beater
time£º2019/1/8 click£º6588
How to replace the vibration mirror of the ring motor(ring motor) laser beater. With the rapid development of acoustic motor(acoustic motor), its application scope has gradually become extensive, covering many fields such as medicine, semiconductors, aerospace, automation industry, and lasers. Among them, the performance and advantages of the swing loop motor(ring motor) have been fully excavated in the laser industry, and are mainly reflected in the mirror locator in laser technology. The swing ring motor(ring motor) is also called vibration motor. In this period, the small editor tells everyone how to replace the vibration mirror for the laser marking equipment of the three major laser devices.
Laser marking machine generally needs to replace the vibration mirror in the following three cases. First, the vibration mirror has been damaged and does not want to repair; The second is to remove the vibration mirror to repair, and then reinstall it; Third, the vibration mirror is the old model, can not meet the requirements to replace the new vibration mirror. In any case, two steps must be used to remove the vibration mirror and install the vibration mirror.
Sound coil motor(sound coil motor) small editor attached to the vibration mirror replacement tips:
1, ensure that the power off the case.
2, unscrew the screw to open the cap and open the relevant baffle.
3, loosen the tie between the vibration mirror and the drive plate.
4, remove the X and Y ring motor(ring motor) and drive board between the motor lines, as well as the power supply lines and signal lines on the drive board.
5, first remove the drive plate, X and Y drive plate removed first to see if there are any obstacles.
6, remove the Y ring motor(ring motor), slowly loosen the Y ring motor(ring motor) fixed clip, when able to move Y ring motor(ring motor), carefully along the installation hole parallel direction pull out the ring motor(ring motor).
7, remove X motor, this step should be noted, loose X coil motor(coil motor) clamping block to support the X coil motor(coil motor) to prevent the coil motor(coil motor) down to cause damage.
Pack up the items that have just been removed.
Tongmao Motor has been deeply cultivating coil Motors(coil motors) for many years. It has the technical experience of Europe and the United States in the industry. It uses customer appeal as its design direction and specializes in customizing sound coil Motors(coil motors) with reasonable performance for customers. Low energy consumption, high precision.
This article originated from the original company of Kunshan Tongmao Electronics Co., Ltd.(www.tmmotion.com). Please indicate the source.
Linear motor